Conrad WH1070 Bedienungsanleitung Seite 73

Briefly press the Alarm button to switch to the alarm setup function (top alarm value
„HI AL"). Then press the Alarm button again; the base station switches to the setup
function for the bottom alarm („LO AL")
Setting sequence for the bottom alarm value
1. Wake-up alarm (same setting as for setting the top alarm value)
2. Bottom alarm value for indoor air humidity.
3. Bottom alarm value for indoor temperature.
4. Bottom alarm value for outdoor air humidity.
5. Bottom alarm value for outdoor temperature.
6. Bottom alarm value for windchill temperature.
7. Bottom alarm value for dew point
8. Bottom alarm value for air pressure
Wake-up time alarm:
Once the set wake-up time is reached, an alarm sounds and the small loudspeaker
symbol next to the time blinks. The alarm sounds for 120 seconds and then goes off.
You can interrupt the alarm by pressing the +/
Indoor/outdoor alarm (weather data alarm):
Once a set alarm condition is reached, an alarm sounds and the corresponding dis-
play icon blinks with the information of whether the top („HI AL") or bottom alarm
(„LO AL") value was the triggering factor. The alarm sounds for 120 seconds and
then goes off. You can interrupt the alarm by pressing the +/
the display icon continues blinking until the alarm condition is no longer given. If the
alarm is triggered again within 10 minutes after the first trigger for the same value,
the alarm does not sound again. However, the display of the corresponding value
will continue blinking until the weather situation has stabilised.
If the alarm is triggered by the outdoor sensor data not shown on the display, the cor-
responding abbreviation of the weather value for which the alarm was triggered
appears on the display.
Example:
When configuring the display, you selected the outdoor temperature and not the dew
point temperature as display value. However, the triggering factor for the alarm is the
dew point temperature. Then the display shows „DEW POINT" (blinking) in addition
to the other alarm symbols. This display tells you that the alarm was triggered by the
dew point temperature.
- button.
- button. However,
73