B) Operating The Cordless Screwdriver; C) Accumulator And Charging Set; D) Led Safety - TOOLCRAFT MD 3,6V-LI Bedienungsanleitung

b) Operating the cordless screwdriver

Rotating parts can catch your hair and clothes, there is risk of injury! Therefore, use a hair net etc. for long hair and wear clothes which
fit closely when operating the product.
Always check the cordless screwdriver for damage before using it. In case you notice any damage, do not operate the device and
bring it to a specialist workshop.
For safety reasons, the change-over switch is to set to its central position before inserting or removing bore bits or drills. In this position
the drive is blocked (turn-on lock).
Ensure that power, gas or water lines are not damaged during boring or screwing in screws! Grave danger!
Take special care if you screw in long screws because they might jam or the cordless screwdriver might slip down, risk of injury!
Never subject the cordless screwdriver to such a high load that the drive will stop.
When boring or screwing above your head, put on appropriate safety goggles. Your eyes might be injured by bore dust or chips.
In some cases an additional breathing mask should be worn which protects your nose, mouth and lungs from dust, an ear protection
is recommended as well.
Hold the cordless screwdriver safely. In case of a sudden stop of the drive (for example, if a drill is interlocked) the torque is transmitted
to the cordless screwdriver itself, it distorts laterally. Due to this, the cordless screwdriver might fall out of your hand, risk of injury!

c) Accumulator and charging set

The accumulator is fixed in the cordless screwdriver (cannot be changed) and may only be charged via the supplied plug-in charging
set. Use the plugin charging set exclusively for the cordless screwdriver!
Only charge the accumulator at an ambient temperature of about 10°C to 30°C.
If the cordless screwdriver/accumulator has warmed up in longer periods of operation, allow it to cool down before charging it.
Protect the product against strong coldness, heat or direct sunlight. Contrary ambient conditions can not only reduce the operating life
of the accumulator but also cause risk of explosion or of destruction of the accumulator in extreme cases.
Do not throw the cordless screwdriver with the accumulator installed into fire, risk of explosion can be caused by the accumulator!
Handle the product carefully, ensure that the cordless screwdriver and plugin charging set do not fall down. Due to the heavy weight of
the product, there is not only the risk of destroying it but also risk of injury.
Never take the accumulator apart.
Short circuits of the contacts of the accumulator can cause risks of fire and explosion!

d) LED safety

Never look directly or with optical instruments into the light beam.
Never point the light beam at mirrors or other reflecting surfaces.
Never point the light beam at people or animals. This can lead to eye or skin injuries.
As much as is possible, direct the light beam so that it is not at eye level.
18