Cleaning The Sensors/Charging Terminals - LG VR64701LVMP Bedienungsanleitung

CLEANING THE SENSORS/CHARGING TERMINALS

There are sensors on the Robot Cleaner that detect obstacles,
stairways and the home station for charging the battery. In order to
maintain the performance of the Robot Cleaner, regularly clean the
sensors and charging terminals as follows:
1. Turn off the power switch on the rear side of the Robot Cleaner.
Injury can be caused by the activation of the Robot Cleaner if the
main power is not turned off.
2. Lay a smooth cloth on the fl oor, turn over the Robot Cleaner and
put it on the cloth.
※ Please make sure to remove the dust bin before rotating the main
body. Otherwise, the dust in the dust bin may fall out.
3. Use a smooth cloth or cleaning brush to wipe the dust off each of the 3 cliff sensors, camera sensors
and ultrasonic sensors and the charging terminal as described below.
Upper camera
sensor
Tip
• Do not clean the Robot Cleaner by directly spraying it with water, thinners, solvents, benzene,
or any other liquids.
• Call the service center if the sensor or charging terminal is damaged. Sensor and terminal
damage can cause the product to malfunction.
32
• To clean the sensor/charging terminals, use the cleaning brush.
Charging terminals
Ultrasonic sensors
Obstacle detecting
sensor window
Detecting sensors
of home station &
Receiving sensors of
remote controller
Cliff detection
sensors
Charging terminals
Bottom camera
sensor
Lens