Lightning Audio LA-1X12V Bedienungsanleitung Seite 3

Model
Woofer Size
Wired
Impedance
Power Handling
(MAX)
Power Handling
(RMS)
Width
Height (A)
Height (B)
Depth (A)
Depth (B)
Enclosure Volume
Tuning Frequency
Installation
Preliminary Considerations:
• If you feel unsure about installing this system yourself, have it installed by a qualified technician.
• Think before you drill! Be careful not to cut or drill into gas tanks, fuel lines, brake or hydraulic lines, vacuum lines or electrical wiring when working on any
vehicle.
CAUTION: Before installation, disconnect the battery negative (-) terminal to prevent damage to the unit, fire and/or possible injury.
1. Run the speaker cable from the amp, avoiding running it close to any sources of high current (wiring harnesses).
2. The positive (+) speaker output from the amp connects to the red terminal of the enclosure, and the negative (-) connects to the black terminal.
NOTE: The woofer(s) is/are pre-wired internally to the impedance listed in the specification chart. Additional impedances can be obtained by re-wiring.
LA-1X12V LA-2X12V
12"
4 Ω
400 watts 800 watts
150 watts 300 watts
19.8"
15.6"
14"
13.5"
16"
3
1.6 ft
35 Hz
12" (2)
2 Ω
33.6"
15.6"
N/A
13.5"
16"
3
3.2 ft
35 Hz