Remote Controller - Bauknecht SPIW312A3BK Gebrauchsanweisung

Remote controller

Insert the batteries into RC
1. Insert a pin and gently press down on the battery
cover and push in the direction of the arrow to
remove, as shown.
2. Insert 2 AAA batteries (1.5V) into the compartment.
Ensure that "+" and "-" polarity is correctly positioned.
3. Close the battery cover on the remote control.
• Remote Control presetting
• Each time the batteries are replaced in the remote
controller, the remote controller pre-set at Heat Pump
mode. The heat pump AC remote controller can be
used to control the cool only AC models.
Note: please follow the intruction which matches to the remote controller you receive for Air Conditioner operation.
Function description of buttons (P1-03)
1. ON/OFF BUTTON
Starts or Stops the appliance by
pressing this button.
3. FAN BUTTON
Used to select fan speed in sequence
auto, high, medium or low.
4-5. TEMPERATURE BUTTON
Used to select the room
temperature.
Used to set the time in timer mode.
6. SMART BUTTON
Sets or cancels Smart operation.
7. SWING BUTTON
Stops or starts horizontal adjustment
louver swinging and sets the desired
up/down airflow direction.
10-11. HUMIDITY BUTTON
Used to set desired humidity level,
they are only available under
6 SENSE mode.
th
16. SUPER SILENT BUTTON
Used to start or stop the super
silent operation to have a low noise
environment.
Symbols on RC display
Cooling indicator
Humidity plus indicator
Humidity minus indicator
Fan only indicator
Heating indicator
Around U indicator
Jet indicator
Auto fan speed
High fan speed
Medium fan speed
Low fan speed
Super silent indicator
ON
Smart Indicator
OFF
Power save indicator
- 30 -
Use RC to control the appliance
• To operate the appliance by remote control, point the
remote control at the receiving device on the indoor
unit, to ensure receiving sensibility.
• To send a message from remote control, the symbol
will flash for 1 second. On receipt of the message, the
appliance will emit a beep.
Signal receptor
• The remote control will operate the air conditioner at
a distance of up to 7m.
• Each time the batteries are replaced in the remote
control, the remote control is pre-set at Heat Pump mode
2. MODE BUTTON
Used to select the operation mode.
in sequence Cooling, hearing or fan.
8. SLEEP BUTTON
Used to select the sleep mode in
sequence of sleep 1, sleep 2, sleep 3
sleep 4 and sleep off.
9. AROUND U BUTTON
Used to set or cancel Around U
function.
12. JET BUTTON
Used to start or stop the fast cooling
or heating.
13. DIM BUTTON
Used to turn on or turn off display
light on indoor unit.
14. WI-FI BUTTON
Used to trun on or turn off the Wi-Fi.
15. TIMER BUTTON
Used to set the time for turn on or
turn off the appliance.
Active RC by pressing UNLOCK button
Sleep indicator 1
Press the button, the
backlight will lighted up
Sleep indicator 2
and function buttons
Sleep indicator 3
will be activated for use.
Press again to lock remote
Sleep indicator 4
controller. If no operation
on remote controller
Display set temperature
for 10s, the remote
Display set timer
controller will be locked
automatically.
Signal transmission
PRESS