9
ADJUSTMENTS
9.6
SEAT ADJUSTMENT ______________________________________________________________
Milsco XB200
Pull out on the adjustment lever located under the left side
of the seat. Slide the seat to the desired position and
release the lever.
Grammer MSG 65
Safety
Driver's seats that have been adjusted incorrectly have a smaller moving area. In order to prevent any personal
injury, the seat must be adjusted for the driver's weight
To prevent injury, no objects should be placed within the moving area of the driver's seat.
To eliminate any risk of accident, the settings must be checked to ensure they are correctly engaged before the
vehicle is driven.
Adjustments must not be made While driving.
Only touch the handle for setting the fore/aft adjustment at the indented grip provided for that purpose (do not put
your whole hand around it). Risk of crushing.
After removal of the backrest upholstery, the backrest frame must be supported, for example held in place, before
the backrest adjuster is operated. If you fail to do so, there is a danger that the backrest frame may jerk forward
and cause injury.
Any changes to the series standard of the seat (for example fitting parts which are not original Grammer AG
parts) may impair the safety standard to which it has been tested. Functions may be impaired, threatening your
safety. For this reason, any changes in design of the seat must be approved by Grammer AG.
Do not hold onto the covers for lifting the driver's seats. If you do so anyway, there is an increased risk injury due
to loosening or breaking covers.
Before you remove the driver's seat, disconnect all plug-in connections between the seat and the vehicle supply
network. When you replace the plug-in connectors, make sure they are tight (dust, water)
Seatbelts are fitted or can be retrofitted to the driver's seat. Seatbelts may only be fitted on approval of the vehi-
cle manufacture, as they increase the load in the seat mounting area. Seatbelts must be fitted in accordance with
specific national regulations and guidelines, and must be approved by Grammer AG.
Seatbelts must be fastened before driving.
The seatbelts must be replaced after an accident.
Where seatbelts are fitted to the driver's seat, the seat and seatbelt mounting must be checked additionally by
specialist personnel after an accident has occurred.
Fasteners must be checked regularly for tight seat. If the seat wobbles, there may be loose bolts or other faults.
en-68