Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Modes of Operation
Operation with the Integrated Controller
The following table provides information regarding the various possible modes of operation. The setting of the
operating mode is carried out using the DIP switch on the back of the device.
The sensitivity of the music control is set using the control next to the mains power connection.
DIP switch > ON
- - -
9
9, 10
9, 11
9, 10, 11
9, 12
9, 10, 12
1
9, 11, 12
Master-Slave Operation
•
Turn ON DIP switch 1 on the intended slave devices to define them as slaves.
•
Connect the DMX OUT connection of the master device with the DMX IN port of the first slave device. Connect
the DMX OUT connection of the first slave device with the DMX IN connection of the second slave device. Carry
out the same procedure with all slave devices.
•
Use the DIP switches 9 and 10 to set the desired programme (see „Operation with the Integrated Controller").
Only programmes marked as „possible in master-slave operation" can be selected.
Function
Music control, colour and pattern changes and movement controlled by the music.
Music control as above, however the light switches off after 10 seconds of no stimulus/signal
Master-slave operation possible
Automatic
colour
Master-slave operation possible
Automatic colour change, flash effect (speed can be set using DIP 5,6,7, and 8) movement
music controlled
Automatic colour change, blink effect, movement and pattern music controlled
Flash effect and movement, colour and pattern changes controlled by the music
Movement, colour and pattern changes controlled by the music, if no impulse/signal is
present switches to automatic colour and pattern changes
Device coded as slave device, controlled via the attached master device
Single colour pattern is selected using the DIP switches from 1-7 (only ever activate one DIP
switch at any time), movement music controlled
change,
movement
music
controlled
21
Werbung
Kapitel
Inhaltsverzeichnis
