Herunterladen Inhalt Inhalt Diese Seite drucken

General Information Regarding The Ce Marking - Hameg HZ547 Handbuch

Vswr messbrücke
Vorschau ausblenden Andere Handbücher für HZ547:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

G e n e r a l i n f o r m a t i o n r e g a r d i n g t h e C E m a r k i n g
DE��LARATION OF ��ONFORMITY
Manufacturer: HAMEG Instruments GmbH
Industriestraße 6
D-63533 Mainhausen
The HAMEG Instruments GmbH herewith
declares conformity of the product
Product name: VSWR Measuring Bridge
Type:
HZ547
with:
Options:
with applicable regulations:
EM�� Directive 89/336/EE�� amended by 91/263/
EWG, 92/31/EE��
Low-Voltage Equipment Directive 73/23/EE��
amended by 93/68/EE��
Harmonized standards applied:
Safety:
EN 61�1�-1:2��1 / IE�� ���EI�� 61�1�-1:2��1
Measuring category II II
Degree of pollution: 2
Electromagnetic compatibility:
EN 61326-1/A1: 1997 �� A1: 1998 �� A2: 2��1/IE��
61326: 1997 �� A1: 1998 �� A2: 2��1
Radiation: Table 4, class B.
Immunity: Table A1
EN 61���-3-2/A14
Harmonic current emissions: Klasse D
EN 61���-3-3
Voltage fluctuations and flicker
Date: 5.�8.2��9
Signature
Holger Asmussen
Manager
10
Subject to change without notice
General information
regarding the CE marking
HAMEG instruments fulfill the regulations of
the EMC directive. The conformity test made by
HAMEG is based on the actual generic and product
standards. In cases where different limit values
are applicable, HAMEG applies the strictest
standard. For emission the limits for residen-
tial, commercial and light industry are applied.
Regarding the immunity (susceptibility) the limits
for industrial environment have been used.
The measuring and data lines of the instrument
have much influence on emission and immunity
and therefore on meeting the acceptance limits.
For different applications the lines and/or cables
used may be different. For measurement opera-
tion the following hints and conditions regarding
emission and immunity should be observed:
1. Data cables
For the connection between instruments resp.
their interfaces and external devices, (computer,
printer etc.) sufficiently screened cables must
be used.
Maximum cable length of data lines must not
exceed 3 m. The manual may specify shorter
lengths. If several interface connectors are provi-
ded only one of them may be used at any time.
Basically interconnections must have a double
screening. For IEEE-bus purposes the double
screened cable HZ72 from HAMEG is suitable.
2. Signal cables
Basically test leads for signal interconnection
between test point and instrument should be
as short as possible. Without instruction in the
manual for a shorter length, signal lines must be
less than 3 meters long.
Signal lines must be screened (coaxial cable -
RG58/U). A proper ground connection is required.
In combination with signal generators double
screened cables (RG223/U, RG214/U) must be
used.
3. Influence on measuring instruments.
In the presence of strong high frequency electric
or magnetic fields, even with careful setup of the
measuring equipment an influence can not be
excluded.

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis