Connecting The Power Supply; Operation - Renkforce EQ-1000 Bedienungsanleitung

Connecting the power supply

Make sure that, before you connect the device to the power supply, the POWER switch (1) is
switched off (position "OFF").
The POWER (1) switch does not entirely disconnect the device from the electricity supply. In
order to completely separate the device from the electricity net, you have to pull the mains plug
out of the wall socket.
• Connect the mains plug of the equalizer's mains cable to a socket (230V~/50Hz) linked to the public power supply
network.

Operation

1
(1) POWER button
This button switches the amplifier on and off.
Position ON > Device is on, alternatively in standby mode (when switched off by the A-1000 Amplifier remote
control) , Position OFF > Device is switched off.
(2) Display reading
The level of the different frequency bands (spectrum display) and the equalizer control setting is shown in
the display.
(3) CURSOR CONTROL button
This button is for setting the individual frequency bands. The blinking cursor in the display (2) is moved in the
direction which the arrow on the button points.
2
11 10 9 8 7 6
3
5 4
23