Task 2: Mounting Vtrak In A Rack - Promise Technology VTrak E-Class Series Kurzanleitung

Task 2: Mounting VTrak in a Rack

The E-Class subsystem and J-class expansion chassis install into the rack using
the supplied mounting rails.
Figure 1 VTrak E610f/s mounted in a rack with the supplied rails
Attaching screw & cage nut sets
(included) upper holes only
Handles mount
outside the rack post
To install the VTrak subsystem into a rack:
1. Check the fit of the mounting rails in your rack system.
2. Adjust the length of the mounting rails as needed.
• At least two persons are required to safely lift, place, and
attach the VTrak subsystem into a rack.
• Do not lift or move the VTrak subsystem by the handles,
power supplies or the controller units. Hold the subsystem
itself.
• Do not install the VTrak subsystem into a rack without rails to
support the subsystem.
• Only a qualified technician who is familiar with the installation
procedure should mount and install the VTrak subsystem.
• Be sure all switches are OFF before you install the VTrak
subsystem or plug in the power.
• Do not mount the rails to the posts using the alignment pins
alone. Always use a screw & cage nut at the end of each rail.
• Use only the supplied screws & cage nuts to attach the rails
and VTrak subsystem.
Task 2: Mounting VTrak in a Rack
VTrak E610f/s
Mounting rails (included)
mount outside the rack post
Cautions
5