Eurochron EFAU 5003 Bedienungsanleitung Seite 3

OPERATING INSTRUCTIONS
Item no. 672570 / version 02/11
RADIO WRISTWATCH EFAU 5003
USE IN ACCORDANCE WITH MANUFACTURER'S
INSTRUCTIONS
This product is intended for displaying the time and date.
The time is set automatically using an integrated DCF receiver.
Always observe the safety instructions and all other information included in these
operating instructions.
This product complies with the applicable National and European regulations. All
names of companies and products are the trademarks of the respective owner. All
rights reserved.
PACKAGE CONTENTS
- Radio Wristwatch
- - Operating Instructions
SAFETY INSTRUCTIONS
Please read all of the operating instructions before using the product
for the fi rst time; they contain important information about the cor-
rect operation. The warranty will be void in the event of damage caused
by failure to observe these safety instructions! We do not assume any
liability for any consequential damage!
Nor do we assume any liability for material and personal damage caused
by improper use or non-compliance with the safety instructions! In such
cases the warranty will be null and void.
- For safety and licensing (CE) reasons, unauthorised conversion and/or modifi ca-
tions of the product are not permitted. Never dismantle the product.
- This product is not a toy and does not belong in the hands of children. The prod-
uct contains small parts that could be swallowed and a battery.
- Do not leave the packaging materials unattended. They may become dangerous
playthings for children.
- Handle the product with care; it can be damaged by impacts, blows, or accidental
drops, even from a low height.
NOTES ON BATTERIES AND RECHARGEABLE
BATTERIES
- Batteries/rechargeable batteries do not belong in the hands of children.
- Do not leave batteries/rechargeable batteries lying around; there is a risk they
could be swallowed by children or pets. If swallowed, consult a doctor immedi-
ately.
- Leaking, or damaged batteries/rechargeable batteries, in contact with the skin
can cause acid burns, therefore, use suitable protective gloves.
- Batteries/rechargeable batteries must not be short-circuited, opened or thrown
into a fi re. There is a risk of explosion!
- Do not recharge normal, non-rechargeable batteries, risk of explosion! Only
charge rechargeable batteries that are intended for this purpose; use suitable
rechargeable battery chargers.
- Check that the polarity is correct when inserting the batteries/rechargeable bat-
teries (pay attention to plus/+ and minus/-).
CONTROLS AND PARTS
DCF RECEPTION
Attempts to receive the DCF signal for daily synchronisation are being made at 2
a.m. and 3 a.m. One successful reception per day is suffi cient to keep the deviation
to less then 1 second.
The DCF signal is encoded and transmitted via a DCF
transmitter in Mainfl ingen (near Frankfurt). Its range
is up to 1500 km and, under ideal reception condi-
tions, even up to 2000 km.
Among other things, the DCF signal includes the pre-
cise time (theoretical deviation of 1 second in a mil-
lion years!) and the date.
This means there is no need for manual setting of
summer and winter time.
If your watch does not display the correct time after delivery, the DCF receiver has
to be triggered manually.
Manual Reception Mode
- Press the trigger (B) with a pointed object, for more than 3 seconds.
- The hour and minute hands run to the 12 o'clock position.
- If this does not happen, please proceed as described in „Hand Positioning".
- If there is DCF reception, the seconds will start to run shortly after.
- The hands automatically set themselves to the current time, after successful DCF
reception.
 
The recognition and interpretation of the DCF signal can take 2-5 minutes. Do
not move the watch, during this time. Do not use any buttons!
Bad reception can be caused, for example, by metalized insulated glass, rein-
forced concrete buildings, coated special wallpapers, proximity to electronic
devices, or installation in cellars.
If the hands are not set to the current time after 10 minutes, change the
clock's location for reception and restart the reception attempt, as described
above.
Positioning the hands
If the hours and minutes hands do not run exactly to the 12 o'clock position when
making a reception attempt, positioning must be performed manually.
- Press the trigger (A) briefl y with a pointed object.
- The Display shows „Po".
- Press the trigger (A) again, the hands can then be set manually. If you press brief-
ly, the hands are moved stepwise. If you press a little longer, the hands begin to
run automatically, which you can interrupt by pressing (A) again.
- When the hands reach the 12 o'clock position, press the button (B) for more than
3 seconds.
- The watch starts an attempt to receive the DCF signal.
- The watch automatically sets itself to the correct time, after successful recep-
tion.
1500 km
2000 km