IDEAL 33-772 Handbuch Seite 13

Screen #L-13
In this case 1-2 is the selected pair to
measure but 1-2 pair is actually shorted, the
screen displays:
• When testing a cable which is connected
to a network device and if the cable has a
shorted pair, then a question " Network?",
" T-Ring Network?" or "XBase-T Network?" appears on the last line of the
display.
Screen #L-14
On a 4-pair data cable, 4-5 is the pair of wire
to measure, all normal cable, the screen
displays:
• Measuring a cable connected to a network
device and if the cable has all the pair wires
shorted, an error message "Out of Range"
will display for a second then followed by a "0 ft" reading; a question "
Network?", " T-Ring Network?" or "XBase-T Network?" appears on the last line
of the display.
• This "Out of Range" phenomenon appears only if the network device has a
inductor coupling which causes a false test result but last just for seconds.
TONE
Tone mode - apply tone to cables,
single or paired wires
To select type of cables to apply tone
1. When in TONE mode, press UP and
DOWN key to scroll through M12,
M12 > RJ-45, RJ-45 of COAX (RJ-45);
press SELECT to select the one to apply
tone
2. Or press MODE and exit to other operation
modes.
RJ45
Shorted 1-2
Xbase-T Network
RJ45
6.0 ft
Xbase-T Network
M O D E = n e x t , S E L = g o
M12
RJ45
Select type to apply
tone
MODE=ESC, SEL=go
13
LENGTH
LENGTH
4-5
TONE
M12>RJ45
COAX(RJ45)