E) Submenu "System Setup - Conrad 55 13 19 Bedienungsanleitung

e) Submenu "System Setup"

Use the buttons "/
of the firmware version ("Software Version"), the TV system for the video output ("TV format") and resetting to factory
settings ("Factory Default").
Setting time/date ("Time Setting")
• Confirm your selection by pressing the button "
• Use the buttons " V-" (20) and " V+" (22) to choose between the settings of the year, month, day, hours and
minutes.
• Adjust the currently selected value with the buttons "/
• Confirm your setting by pressing the button "
• To leave the submenu, push the button "
Display firmware version ("Software Version")
The firmware version of the indoor unit ("RX") and the outdoor unit ("TX") are displayed. There are no other setting
or selection options.
Switch TV system between PAL/NTSC ("TV Format")
• Choose between "NTSC" and "PAL" with the buttons " V-" (20) and " V+" (22). This setting only applies for the
AV output (31).
• Confirm your selection by pressing the button "
• To leave the submenu, push the button "
Resetting to factory settings ("Factory Default")
• To reset the indoor unit to factory settings, push the button "
• A safety prompt appears. Use the buttons " V-" (20) and " V+" (22) to choose the symbol "X" (cancel) or "O"
(OK, reset to factory settings) and push the button "
If "O" is selected, a rotating arrow symbol appears. After a few seconds, "OK" will be displayed; the indoor unit is
reset to factory settings.
• To leave the submenu, push the button "
42
" (18) and "/ " (21) to choose between the settings of time/date ("Time Setting"), display
" (19).
OK
" (18) and "/
" (19).
OK
/ESC" (23).
" (19). The display briefly shows "OK".
OK
/ESC" (23).
" (19).
OK
" (19).
OK
/ESC" (23).
" (21).