Affixing The House Number; Replacing/Installing The Battery - brennenstuhl SH 4000 E Bedienungsanleitung

Solar power with external solar panel
Step 11 : Connect solar cell to circuit
board
Plug the connecting lead into the socket in
the solar panel.
Fig. 6: Solar panel
On completing the installation, remove the
protective foil from the solar cell.
Period of illumination:
Dull days: up to 5 hours
Sunny days: over 9 hours
7.2 Affixing the house
number
Step 1 : Remove pull-off foil
Remove the pull-off foil from the protective
paper.
Step 2 : Affix the house number to
the pull-off foil
Affix the house numbers/letters (incl. the
protective paper) to the adhesive-coated
side of the pull-off foil.
- For 3-digit numbers, use the red
characters.
- For 2-digit numbers, use the blue
characters.
Pull off the protective paper from the
numbers/letters. These are also coated
with adhesive.
Step 3 : Affix pull-off foil to window
Affix the pull-off foil to the window with
uniform lateral and vertical spacings.
User's Handbook SH 4000 E
6
13
NOTE: Take care to ensure that the
pull-off foil lies flat and is evenly attached.
Press down the house numbers/letters on
to the window.
Step 4 : Remove the pull-off foil
Remove the foil carefully and slowly. The
house numbers and letters will now be
permanently affixed to the window.
7.3 Replacing/installing the
battery
The house number light is powered by a
battery. It needs no additional power supply.
Step 1 : Separate the two parts of
the light
See Section 7.1
Step 2 : Remove the old battery
Remove the battery from the battery holder.
NOTE: Observe the disposal
instructions (Section 10).
Step 3 : Install new battery
IMPORTANT: Install battery [3] in the
battery holder [8], observing the correct
polarity.
3
Fig. 7: Control electronics, including battery
Step 4 : Reassembling the light
See Section 7.1
18
8
Stand: 02_2007 rév. 01