Wireless Camera
1.Microphone –Captures the sound on camera side and transmits the sound from camera to receiver.
2. 6W white LEDs –White LED light comes with manual, motion and timer activation
3. Camera Lens –Catches the video in front of the lens and transmits video from camera to receiver.
4. IR LEDs – Infrared LEDs provide viewing in no/low light conditions
5. PIR Sensor – Detects motion in front of the lens and emits detection signal to transmitter.
6. Speaker – Produces the sound transmitted from the receiver.
7. Camera Antenna – Sends & receives signals to or from the receiver.
8. Wall Mounting Bracket – Use the bracket to mount the camera on a wall or other flat surfaces.
9. AC Adaptor Jack – Plug the AC adaptor to the jack for camera's power supply.
10. Pair Button – The pair button is located on the back of the camera, it is used to pair the camera with
receiver.
Note: This camera includes an Auto Mechanical IR Cut Filter. When the camera changes between day
mode and night vision mode, an audible clicking noise may be heard coming from the camera. This
clicking is normal, and indicates that the camera filter is working.
Camera Installation
Before you install the camera, carefully plan where and how it will be positioned, and where you will
route the cable that connects the camera to the power adaptor.
Before starting permanent installation, verify its performance by observing the image on the receiver
when camera is positioned in the same location/position where it will be permanently installed and the