Display Indication And Symbols; Power The Product - VOLTCRAFT VC610BT Bedienungsanleitung

8.

DISPLAy INDICATIoN AND SyMBoLS

AUTO
MANUAL
TRMS
HOLD
OL
~ AC
DC
mV
V
A
mA
µA
Hz
kHz
MHz
VA
ºC
ºF
Ω
kΩ
MΩ
nF
µF
mF
9.

PoWER THE PRoDUCT

The product is powered by either six 1.5 V batteries type C or 230 V/AC, 50 Hz. Based on your needs,
select one of the methods below to power the product.
Battery
Disconnect the product from the power source before opening the power
compartment.
Disconnect the measuring leads from the product before opening the power
compartment.
Never operate the meter when it is open. Danger to life!
A new, fully charged battery must be inserted at initial commissioning or if the battery change symbol
appears on the display.
42
Automatic measuring range selection
Manual measuring range selection
True root mean square
Data hold function
Overload (measuring range exceed)
Battery replacement symbol (low battery level)
Diode test
Acoustic continuity tester
Alternating current for voltage and current
Direct current for voltage and current
millivolt (= 0.001 V)
Volt (unit of electric voltage)
Ampere (unit of electric current)
milliampere (= 0.001 A)
Microampere (=0.000001 A)
Hertz (unit of frequency)
Kilo Hertz
Mega Hertz
Voltampere (unit of electric apparent power)
Degree Celsius (unit of temperature)
Degree Fahrenheit (unit of temperature)
Ohm (unit of electric impedance)
Kilo Ohm (= 1000 Ω)
Mega Ohm (= 1000000 Ω)
Nanofarad (unit of electric capacity, = 0.000000001 F)
Microfarad (= 0.000001 F)
Millifarad (= 0.001 F)
Symbol for capacitance measurement