Testing The System; Technical Specifications - Eufab 16227 Bedienungsanleitung

14. Next splice the black wire of the transmitter box power cable to the reverse light's
negative (-) wire or ground.
15. Replace the reverse light bulb, and then re-install the light socket. Secure all the
wires with cable ties or electrical tape.
16. Re-attach the negative battery cable to the battery.

TESTING THE SYSTEM

1. Reattach the vehicle's negative battery cable.
2. Turn the ignition key to the accessory position, do not start the vehicle.
3. Engage the parking brake, and then put the shifter in the reverse position.
4. Turn the monitor ON by pressing the ON/OFF button on the monitor.
5. Look at the monitor, if the image does not match your rear view mirror press the
Image Orientation button on the monitor to correct the image.
After testing the unit and you are satisfied with the route you have chosen for the
cabling, you must permanently install it.
Fully tighten the license plate bolts.
Route all wires behind interior panels or under carpeting so they are hidden.
Use supplied cable ties to neatly gather any excess wire.

TECHNICAL SPECIFICATIONS

Description
Operating Voltage range
Operation Temperature
Storage Temperature
Camera + transmitter
Current consumption
Image Sensor
No. of pixel
Camera View Angle
Transmission frequency
RF transmission distance
Monitor
Display
Video Input (wireless
receiver)
No. of pixel
Test Condition
DC PowerSupply
with Transmitter Module
1/4 inch Color CMOS
Measure Horizontal, 3m from camera
using Spectrum analyser (select)
open
2.4" TFT LCD
11
Nominal Value
12V
-10 to +45 °C
-20 to +80 °C
150mA
640x480pixel
110 degree
2.4 GHz
+/- 60m
1x 2.4GHz
480x240pixel