BE QUIET! DARK BASE 700 Handbuch Seite 10

4.5 HANDLING OF THE LED ILLUMINATION
The LED illumination preinstalled in the front can be configured in several colors and operating modes. Further
strips of LED illumination for lighting the case interior can be plugged into socket "D" on LED controller PCB
(4.3) with a maximum combined rating of 24 watts.
WARNING! Only 12V LEDs may be connected.
To switch between synchronized operation and manual control mode keep switch "G" pressed for about three
seconds.
Synchronized operation
It is possible to connect cable "C" of the PCB (4.3) and the corresponding RGB LED controller socket of your
motherboard. The integrated illumination can then be controlled by the motherboard.
For information on operation of the LED controller of your motherboard refer to your motherboard handbook.
In manual mode you can cycle through the available colors (white, red, green, blue, orange, purple) by briefly
pressing switch "G". An intermediate stage between each color enables "breath mode" for the previously
selected color.
The individual switch stages are:
1 White
2 White breath
3 Red
4 Red breath
5 Green
6 Green breath
7 Blue
10
8 Blue breath
9 Orange
10 Orange breath
11 Purple
12 Purple breath
13 Breath mode alternately in all colors
14 LEDs off