Using The Drive; Power-Saving Mode - Panasonic CF-VEBC11U Bedienungsanleitung

Using the Drive

<Only for model with CD/DVD Drive>
Setting a Disc
■
Turn on the computer.
A
Press the eject button (A) and slowly pull out the tray.
B
Insert/Remove the disc.
C
To insert
•
Set the disc with the label side up and press the center of
E
the disc until it clicks in place.
To remove
•
Press on the center spindle (B) and carefully lift up the edge
of the disc.
Close the tray.
D
Do not press the eject button.
NOTE
To remove a disc when the computer is powered off, insert a pointed object (e.g., the bent-out tip of
●
a paper clip) into the emergency hole (C). Pushing it to the end allows the tray to come out.
If the vibration of the drive is excessive, check the disc.
●
For AutoPlay CD/DVD:
●
If an AutoPlay CD/DVD does not start after the computer resumes from sleep (
•
standby (
Windows XP
waiting 15 seconds.
An AutoPlay CD/DVD may start during file access depending on the status of the disc.
•
When playing back video from a disc, playback may not be smooth in some conditions
●

Power-saving Mode

If the drive is not accessed for 30 seconds, the drive motor will automatically be shut down to reduce
the power consumption. When the drive is accessed again, the drive motor is turned on. In this case,
reading of the disc data will take approximately 30 seconds.
To play DVD-Video or MPEG2 files
■
Install the DVD playback software using "DVD Drive Utility Disc" (included).
For information on how to install the software, refer to "Operating Instructions Software Guide" with
"DVD Drive Utility Disc".
14
) or hibernation, remove the disc from the drive and then reinsert it after
),
Windows 7