Technical Data; Cleaning And Maintenance - bredeco BCPP 40-9 Bedienungsanleitung

U S E R M A N U A L
The operation manual must be read carefully.
Never dispose of electrical equipment together
with household waste.
This machine conforms to CE declarations.
Attention! Hot surface may cause burns.
PLEASE NOTE! Drawings in this manual are for
illustration purposes only and in some details may
differ from the actual product.
The original operation manual is in German. Other
language versions are translations from German.
USER MANUAL
SAFETY INSTRUCTIONS
General safety information for the use of electrical devices:
To avoid injury from fire or electric shock, please ensure
compliance with safety instructions when using this device.
Please read the instructions carefully and make sure that
you have understood them well. Keep the manual near the
equipment to be able to read it at any time. Always use
current sources connected to the ground and providing the
necessary voltage (indicated on the label on the device). If
you have any doubt, let an electrician check that your outlet
is properly grounded. Never use a damaged power cable.
Do not open the unit in damp or wet environment, or if your
hands or body are damp or wet. Protect the unit from solar
radiation. Use the device in a protected location to avoid
damaging the equipment or endangering others. Make sure
the device is able to cool and avoid placing it too close to
other devices that produce heat. Before cleaning, disconnect
it from the power source. Use a soft damp cloth for cleaning.
Avoid using detergents and make sure that no liquid enters
the unit. No internal element of this device needs to be
maintained by the user. Opening the device without our
approval leads to a loss of warranty!
SAFETY GUIDELINES
1. Please read and understand these instructions
carefully before operating the device! Please observe
the safety guidelines carefully in order to prevent
damages through improper use!
2. Please keep this manual available for future
reference. If this device is passed on to third parties,
the manual must be passed on with it.
3. Only use this device indoors and for its intended use.
4. We do not offer any warranty for damages resulting
from improper use or incorrect operation.
5. Before the first use, please check whether the main
voltage type and current comply with the indicated
data on the type plate.
6. This device is not intended to be used by persons
(including children) with limited physical, sensory
or mental aptitude or lack of experience and/or
knowledge, unless they are supervised by a person
responsible for their safety or have received instruction
from this person as to how the device is used.
7. ELECTRIC SHOCK HAZARD! Do not attempt to repair
the unit yourself. In case of device failures, repairs
must be done by qualified experts.
8. Please check the main plug and the power cable
regularly. If the power cable for this device is
damaged, it has to be replaced by the manufacturer
or its customer service or another qualified person in
order to prevent hazards.
EN
9. Prevent damages to the power cable by avoiding
squeezing or bending it or rubbing it on sharp
edges. Also keep the power cable away from hot
surfaces and open flames.
10. ATTENTION! DANGER TO LIFE! While cleaning, never
immerse the device in water or other liquids.
11. Under no circumstances should the housing be
opened.
12. Before every use of the device, make sure the
temperature control instrument is properly inserted
to the socket in the casing, i.e. the thermoregulator
must be set well in its position. If you insert the
regulator incorrectly, the device may overheat, which
– as a result – may cause an accident or damage.
13. Keep the thermoregulator socket
thermoregulator clean to minimize the risk of
damage or accident.

TECHNICAL DATA

Product name Pizza Pan
Model BCPP 40-9
Rated voltage [V]/Frequency [Hz] 230~/50
Rated power [W] 1400
SCOPE OF APPLICATION
The pizza pan is only for making and re-heating dishes for
household purposes.
Do not use the heating surface for:
• heating liquids or flammable materials,
• heating premises,
• drying wet items (e.g. clothes, boxes, etc.).
The user is liable for any damage resulting from non
-intended use of the device!
BERORE THE FIRST USE
Upon receipt of the goods, check the packaging for
integrity and open it. If the packaging is damaged, please
contact your transport company and distributor within 3
days, and document the damages as detailed as possible.
Do not turn the package upside down! When transporting
the package, please ensure that it is kept horizontal and
stable.
DISPOSAL OF THE PACKAGING
Please keep all packaging materials (cardboard, plastic
tapes and Styrofoam), so that in case of a problem, the
device can be sent back to the service centre in accurate
condition!
INSTALLING THE APPLIANCE
APPLIANCE LOCATION
The temperature of environment must not be higher than
45°C and the relative humidity should be less than 85%.
Ensure good ventilation in the room in which the device
is to be used. The distance between the back of the chain
toaster and the wall should be at least 20 cm, minimum
distance between the sides of the device and the walls
should be at least 10 cm on each side and 35 cm between
the top of the device and the ceiling. Keep the device away
from hot surfaces. Operate the device on flat, stable, clean,
refractory and dry surfaces out of the reach of children and
people with mental disabilities. Install the device making
sure that constant access to the main plug is ensured. The
power cord connected to the appliance must be properly
grounded and correspond to the technical details. Before
the first use, remove all elements and clean them along
with the entire device!
6
DEVICE OPERATION – BASIC PRINCIPLES
View of the device
4
6
and the
Device description
1. cover handle
2. cover
3/4. handle
5. hotplate
6. casing
7. thermoregulator socket
View of the thermoregulator
1
3
Description of the thermoregulator
1. Control light
2. Temperature control knob
3. Temperature tester
Place the thermoregulator into its socket in the casing of
the device, leaving some space enabling good access to
the temperature control knob. Put the plug into the power
socket and, by means of the knob, set the right heat level
for the device.
Thermostat Temperature
level [°C]
MIN – 1 100~150
2 150-160
3-4 160~200
5 ~250
EN
The light on the thermoregulator should turn on to show
that the coil heater is working. When the light goes out,
1
it means that the temperature of the hotplate has risen
to the set level and you can place food on it. Prepare the
2
dish to suit your taste and according to the recipe. Cover
the frying pan with the dedicated cover. When you have
finished your work on the device, turn the thermoregulator
knob to the OFF position and remove the plug from the
3
power socket. Wait until the frying pan has cooled down
and then clean the device according to section ‚Cleaning
5
and Maintenance' in this manual.
TRANSPORTATION AND STORAGE
Shaking, crashing and turning upside down of the device
should be prevented when transporting it. Store it in
a properly ventilated location with dry air and without any
7
corrosive gas.

CLEANING AND MAINTENANCE

• Always unplug the device before cleaning it.
• Do not clean the device under running water. It is
forbidden to use a pressure jet of water to clean the
device.
• Make sure no liquids used for washing get into the
thermoregulator socket nor the thermoregulator.
• Clean the thermoregulator with a dry cloth or paper
towel. It is forbidden to clean the thermostat with
water.
2
• Use cleaner without corrosive substances to clean
surface.
• For cleaning the elements of the device use only
soft materials, i.e. cloths, sponges, etc. which do not
scratch the surface.
• Dry all parts well after cleaning before the device is
used again.
• Store the unit in a dry, cool place, free from moisture
and direct exposure to sunlight.
CHECK REGULARLY THE DEVICE
Check regularly whether the device is damaged. If it should
be damaged, please stop using it immediately and contact
your customer service to solve the problem. What to do in
case of a problem? Please contact your customer service
and prepare the following information:
• Invoice number and serial number (the latter is to be
found on the technical plate on the device).
• If relevant, take a picture of the damaged, broken or
defective part.
• It will be easier for your customer service clerk to
determine the source of the problem if you give
a detailed and precise description of the matter.
Avoid ambiguous formulations like "the device does
not heat", which may mean either that it does not
heat enough or that it does not heat at all. The more
detailed your information, the better the customer
service will be able to solve your problem rapidly and
efficiently!
Purpose
CAUTION: Never open the device without the authorization
of your customer service. This can lead to a loss of warranty!
Heat maintenance
Toast, hamburger, etc.
Product name
Model
Pancakes, scrambled
Power
eggs, ham, bacon,
Voltage/Frequency
sausages, cake, etc.
Weight
Production year
Pizza, grilled food
Manufacturer: expondo Polska sp. z o.o. sp. k.
ul. Dekoracyjna 3, 65-155 Zielona Góra | Poland, EU
7
Design Made In Germany | expondo.de
Pizza Pan
BCPP 40-9
1400W
230V~/50Hz
3.7 kg