Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
IWS 65
Technical details
Speaker
For correct polarity:
Connect the plus to the red
speaker connector
Connect the minus to the
black speaker connector
Please note: If one or even more
speakers are connected with the
wrong polarity, there is a
significant reduction in the bass
reproduction and the sound
portrait is uneven and diffused.
Cable lengths and diameters
speakers show a
REVOX
balanced electrical impedance
and phase response, which
means that they represent an
uncritical load for the output
amplifier and the speaker cable.
In order to keep the cabling and
high frequency losses to a
minimum, we recommend that
you use cables with the following
diameter and always to use 2-
core cables.
Up to 15 m:
Ø 0.75 mm
Up to 30 m:
Ø 1.50 mm
Over 30 m:
Ø 2.50 mm
Up to 50 ft:
AWG 17
Up to 100 ft:
AWG 14
Over 100 ft:
AWG 12
21
We would advise against
having cable runs longer than
50 metres (165 ft) because of
an unavoidable loss in HiFi
reproduction.
Load capacity
The power capacity details
given on the
refer to a linearly set sound
controller at the amplifier.
You can use these speakers
with an amplifier with a higher
output performance. In this
case, however, you must
ensure that the volume is not
turned up so high that your ear
becomes aware of an overload.
You will become aware of this
in good time by an increase in
sound distortion.
A short-term overload will not
damage your
If the chassis should be
damaged by a long-term
overload, this will be clearly
identifiable for a service
2
technician. In this case, you are
2
no longer covered by your
V
2
RE
OX
V
rating plate
RE
OX
V
speakers.
RE
OX
guarantee.
Werbung
Kapitel
Inhaltsverzeichnis
