Installation Onto The Pipe; Installation Of The Fitting Onto The Pipe - bürkert 8025 Bedienungsanleitung

Warning
risk of injury due to non-conforming installation.
▶ The fluid installation can only be carried out by qualified and
skilled staff with the appropriate tools.
▶ Respect the assembly instructions for the fitting used.
risk of injury due to unintentional switch on of power supply
or uncontrolled restarting of the installation.
▶ Take appropriate measures to avoid unintentional activation of the
installation.
▶ Ensure that the restart of the installation is controlled after any
interventions.
protect this device against electromagnetic inter-
ference, ultraviolet rays and, when installed outdoors,
the effects of the climatic conditions.
7.2

installation onto the pipe

The device type 8025 must be engaged in a fitting type S020 that is
mounted on the pipe.
The SE35 electronic module has to be mounted on a sensor-fitting
(S030, for example) mounted on a pipe.
12
English
Type 8025 / SE35, battery powered
Installation
7.2.1 installation of the fitting onto the
pipe
→
Choose a fitting appropriate to the velocity of the fluid inside the
pipe: refer to the graphs hereafter
→
Install the fitting on the pipe, as described in the Operating
Instructions of the fitting used.