Start Up; Fill In Engine Oil; Check Oil Level; Refuel - Zipper ZI-RD300 Betriebsanleitung

29.3

Start up

29.3.1 Fill in engine oil

ATTENTION! For transport engine oil has been drained. Fill up with 4-
stroke quality motor oil before first operation! Failure to do so will result
in permanent engine damage and void guarantee!
 Use engine oil (SF 15W40)
 Remove oil cap (1)
 Fill in engine oil (Engine oil tank capacity 0,6l: do
not overfill!)
 Tighten the oil cap
 Wipe any oil residues

29.3.2 Check oil level

 Place machine on a level ground
 Remove oil cap
 Wipe oil from the dipstick
 Replace the dipstick without tightening the oil cap!
 Pull out the dipstick again.
 Check the oil level. Oil level must be between min and max
 Fill in oil if low level

29.3.3 Refuel

Use only unleaded fuel with min. 95 octane or higher
Never use 2-stroke mixture of diesel! DAMAGE OF ENGINE
 Refuelling only outdoors!
 Before removing the filler cap, turn the
engine off and let it cool machine
 Clean the fuel filler cap area
 Remove the filler cap carefully
 Fill in fuel
 Fuel tank capacity: 3,6 l. Fill tank only
up to 1,5 cm below the rim of the filler
neck, so that the fuel has place for
expansion.
 Replace and tighten the filler cap
 Wipe any fuel residues and wait until it
evaporates
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-RD300
W A R N I N G
W A R N I N G
OPERATION
32