Waeco MOBITRONIC M45R Montage- Und Bedienungsanleitung Seite 34

_M45.book Seite 34 Freitag, 21. November 2008 11:05 11
Mounting the monitor
7.5 Connecting the monitor to an electricity supply (fig. e, page 10)
The circuit diagram for the monitor can be found in fig. e, page 10.
No. Description
1 Rear view of the monitor
2 Light switch
3 Switch for the rear headlamp
4 Ignition socket
5 Branch connector or soldering point
6 Instrument illumination
7 Reverse headlamp
8 Camera
br brown
rt red
sw black
ws white
Observe the following instructions when laying the connection cable:
Note
I
Feed the connection cable through existing ducts or other openings where pos-
sible e. g. ventilation grilles. If no appropriate ducts or openings are available
you will need to drill a hole of ∅ 18 mm. Check beforehand that there is sufficient
space on the other side for the drill head to come out (fig. 2, page 4).
Note
I
Please observe the notes from the chapter "General information on the electrical
connections" on page 29.
➤ Plug the connection cable into the power socket (fig. b 4, page 7) on the back of the
monitor.
Caution!
e
Make sure the polarity is correct when connecting to a voltage source.
➤ Connect the red and black cables of the connection cables to a suitable voltage source:
– Connect the red cable to terminal 15 (ignition).
– Connect the black cable to terminal 31 (earth).
➤ Connect the brown cable to the positive cable of the reversing light (7).
34
M45R