Technical Data; Mounting The Handle - Bosch GAS 50 M Professional Originalbetriebsanleitung

OBJ_BUCH-877-001.book Page 16 Wednesday, February 18, 2009 11:21 AM
16 | English

Technical Data

Wood vacuum cleaner
Article number
Rated power input
Container volume
(gross)
Net volume
Dust bag contents
Vacuum*
Airflow*
Suction capacity
Surface of folded filter
Dust category (BIA)
Weight according
to EPTA-Procedure
01/2003
Protection class
BIA test certificate
number
* measured at the blower
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltage and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your vacuum cleaner. The trade names of the individual
vacuum cleaners may vary.
1 609 929 K11 | (18.2.09)
Assembly
GAS 50 M
Professional
0 601 988 1..

Mounting the Handle

W 1200
The vacuum cleaner cart is designed in such a
manner, that the vacuum cleaner can be pushed
easier with the push handle 16. Always grasp
l 50
the push handle 16 with both hands when push-
l 43
ing the vac.
l 21
Insert the push handle 16 into the 2 openings of
mbar 225 the container 11. Push the clamps 15 through
the corresponding holes of the push handle 16
l/s 39
and then lock the clamps 15.
W 316 (6 mbar)
The casters are equipped with brakes 12. To ac-
2
cm 8600
tuate the castor brake 12 press the lever down-
wards.
M
Replacing/Inserting the Dust Bag
(see figure A)
kg 17.4
– Unlock the latches 13 and remove the vacu-
/I
– Pull off the full dust bag 17 from the connec-
200220710/
– Slide the new dust bag 17 over the connec-
1110
– Lock the latches 13.
For dry vacuuming operation, a dust bag 17
should be inserted. When operating with a dust
bag 17, the folded filter 18 clogs slower, the vac-
uuming performance is kept up longer and the
disposal of dust becomes easier.
When materials not hazardous to one's health or
materials with or without an exposition value of
≥ 1 mg/m
now application category U) are being vacu-
umed, it is possible to vacuum directly into the
container.
Before any work on the vacuum cleaner it-
self, pull the mains plug.
um lid 3.
tion flange toward the rear. Close the open-
ing of the dust bag by folding down the lid.
Remove the closed dust bag from the vacu-
um cleaner.
tion flange of the vacuum cleaner. Make sure
that the full length of the dust bag 17 faces
against the inner wall of the container 11.
Reattach the vacuum lid 3.
3
according to dust category L (until
Bosch Power Tools