Timer - Kübler CODIX 560 Bedienungsanleitung

INP A: Frequency input A
INP B: Frequency input B
Percentage differential
measurement [(A-B) / A in %]
INP A: Frequency input A
INP B: Frequency input B
User input 1
User input 2
When the MPI input is activated
the display is "frozen" and
remains "frozen" until the MPI
input is deactivated.
Internally the frequency meter
continues running
(Display store).
When the MPI input is activated
the current frequency for the
preset that has just been
selected will be adopted as the
new preset value.
(See also 8.2.2)
Lock input
When the Lock input is activated
the programming is inhibited
When the Lock input is activated
the setting of the preset values is
inhibited.
When the Lock input is activated
the setting of the preset values
and the programming are both
inhibited
7.8.4.2 Submenu for configuration
Submenu for matching the input
pulses to the display.
Multiplication factor
can be programmed from
00.0001 to 99.9999 .The setting
00.0000 will not be accepted
Division factor
can be programmed from
01.0000 to 99.9999
A setting < 01.0000 will not be
accepted.
Display mode
Calculation and display of the
frequency / speed in 1/sec
Calculation and display of the
frequency / speed in 1/min
Decimal point setting
(determines the resolution)
0
0.0
0.00
0.000
Moving average
Moving average calculated
AVG 2
AVG 5
AVG 10 over 10 measurements
AVG 20 over 20 measurements
Start delay
Programmable from 00.0 up to
99.9 sec.
At the start of a measurement the
measurement results within this
time-period are ignored.
Waiting time
Programmable from 00.1 up to
99.9 sec.
This value specifies how much
time should elapse, after the last
valid edge, before zero is to be
displayed.
7.8.4.3 Preset 1
See below 7.9.5.5
7.8.4.4 Preset 2
See below 7.9.5.6

7.8.5 Timer

7.8.5.1 Submenu for the Signal and
Control inputs
Submenu for programming the
signal and control inputs
Input polarity
PNP: switching to Plus
for all inputs in common
NPN: switching to 0 V
for all inputs in common
Filter for signal inputs INP A
and INP B
for electronic control of the
signal inputs
for mechanical control of the
signal inputs (for control with
mechanical contacts)
no decimal place
1 decimal place
2 decimal places
3 decimal places
over 2 measurements
over 5 measurements
Page 11