Philips S91XX Bedienungsanleitung Seite 23

flashes. When the drying phase is done (after approx. 4 hours),
the drying symbol lights up continuously (Fig. 49).
When the cleaning program is done, the ready symbol lights up
continuously (Fig. 50).
30 minutes after the cleaning program and charging have been
completed, the SmartClean system switches off automatically.
The battery symbol lights up continuously to indicate that the
shaver is fully charged (Fig. 50). Charging takes approx. 1 hour.
5 SmartClean system Basic only: To let the shaver dry, you can leave
it in the SmartClean system until your next shave. You can also
remove the shaver from the SmartClean system, shake off excess
water, open the shaving unit and let the shaver air dry.
Note: If you press the on/off button of the SmartClean system during
the cleaning program, the program aborts. In this case, the rinsing or
drying symbol goes out.
Note: If you remove the supply unit from the wall socket during the
cleaning program, the program aborts.
Replacing the cartridge of the SmartClean system
Replace the cleaning cartridge when the replacement symbol flashes
orange or when you are no longer satisfied with the cleaning result.
If you clean the shaver in the SmartClean system once a week, the
SmartClean cartridge lasts approximately three months.
1 Press the button on the side of the SmartClean system (1) and lift
the top part of the SmartClean system (2) (Fig. 43).
2 Remove the cleaning cartridge from the SmartClean system and
pour out any remaining cleaning fluid (Fig. 51).
You can simply pour the cleaning fluid down the sink.
3 Throw away the empty cleaning cartridge.
4 Unpack the new cleaning cartridge and pull off the seal (Fig. 44).
5 Place the cleaning cartridge in the SmartClean system (Fig. 45).
6 Push the top part of the SmartClean system back down ('click')
(Fig. 46).
23
English