CO/Tech 18-2860 Original Bedienungsanleitung Seite 4

Assembly
1. Remove the 3 screws in
the base of the tower fan.
2. Place the mains lead in
the hole in the middle of
the base and push the 2
halves of the base together.
3. Fasten the mains lead in
the cable holder in the base
and pass it through
the opening in the side of
the base.
4. Fasten the base back onto the tower fan using the 3 screws. Note: The screw
holes are asymmetrically placed so the base only fits on one way.
5. Place the fan on a firm, flat surface and make sure that the mains lead comes out
of the opening in the side of the base.
4