Safety instructions
WARNING! Electric shock! There is a risk of
an injury caused by electric shock!
Operation is only allowed with a safety
switch against stray current (RCD max. stray
current of 30mA).
Please follow these instructions to protect your-
self and other persons against potential risks and
injuries.
•
Comply with the local injury prevention re-
gulations and safety regulations in the work
area.
•
Do not touch, inhale (dust development) or
consume the cement or additive. Personal
protective clothes to be worn when fi lling or
emptying the mixer drum.Gloves, protective
glasses, anti-dust respirator to be worn.
•
Install and operate the concrete mixer on a
solid and fl at surface (making sure it does
not fall over).
•
To prevent tripping, remove any obstacles
on the site.
•
Adequate light conditions must be provided.
•
The operator is responsible to third persons
in the work area.
•
Do not operate the mixer unattended.
•
Do not let children near the mixer.
•
Mixer to be only used for works given in para-
graph „Use as designated".
•
Do not modify the machine or any of its
parts.
•
Defective or damaged parts of the machine
to be immediately replaced.
•
The mixer can only be put into operation with
complete and intact safety equipment.
•
Never touch inside the running mixer drum.
(rotary stirrer). Keep adequate safety distance
from the mixer. Prevent any contact with the
rotary or moving parts of the machine.
•
The mixer drum to be only fi lled and emp-
tied when the engine is running.
•
Pay attention to the mixer drum rotation
direction.
•
Do not change the engine revolutions as
they regulate the maximum safe work speed
possible and protect the engine and all rotating
parts against damage by excessive speed.
•
Move the concrete mixer, not designed by the
manufacturer for operation with trailer, by
manual movement.
•
The mixer must necessarily be unplugged
before:
•
relocation and transport
•
cleaning, servicing and repair
•
failure removal
•
Check the connecting cables if not knotty
or damaged
•
Leaving (even in case of short interrup-
tion)
•
Check the machine for any damage:
•
Before using the equipment again, the
protective equipment must carefully
be checked if safe and working as
designated.
•
Check the moving parts for perfect
functioning, if working smoothly and if
no parts are damaged. To provide safe
operation of the equipment, all parts
must be installed properly and meet all
conditions.
•
Damaged protective equipment and
parts must be professionally repaired or
replaced by a recognised professional
workshop, unless otherwise specifi ed in
the Operating Instructions.
•
Any damaged or illegible safety stickers
must be replaced.
•
Keep any equipment not being used in dry and
locked spaces.
Concrete mixer with protective
insulation
II)
•
The machine can only be put into operation
when the cladding is complete and fi rmly
enclosed.
•
The protection class II will only be maintained
when original insulation materials/components
are used for a repair and when the insulation
distances are not changed.
Electrical safety
A risk to life when the above-mentioned provision
is not complied with!
•
Design of the connecting cables according
to IEC 60245-4 1980 (DIN 57 282) with H 07
RN-F marking or equivalent types of design.
Core cross section of at least 3 x 1.5 mm2 for a
maximum length of 25 m. Core cross section of
at least 2.5 mm2 for a length a
ENGLISH
21
(Protection class