MS Schippers 0803702 Gebrauchsanweisung Seite 5

Peristaltic pump for MS Powermister
1. Supplied parts
Supplied Parts
1: Peristaltic pump including suction tube
2: Back plate for mounting on MS Powermister
2. Assembly
Step 1:
Attach the pump using the supplied back plate to the frame of the MS Power mister.
Step 2:
Connect the cable to the present plug.
Note the colours of the thread:
MS Powermister
White or yellow
Black or yello
Step 3:
Hang the suction tube in the container of the MS Power mister.
Step 4:
Insert the low pressure tube to the nozzle at the dosing device.
The pump is now ready for use. Make sure the dosing tap of the MS Powermister during
use is always fully opened.
3. Maintenance
After each use, rinse the pump with clean water for 2 minutes.
The peristaltic pump is not suitable for oily liquids.
Check before every use if the hoses are still leak tight. (Check daily and replace monthly)
A new tube set can be ordered under art.nr.: 8806733.
The tube set for pump MS Powermister contains a piece of tube, 2 tube pillars and a
plastic clip.
Pump
Brown
Blue
5