Setting The Signal Type; Setting The Volume - Silvercrest IAN 273554 Bedienungsanleitung

The signal indicator
cate the synchronisation is successful.
NOTE: The synchronisation mode can only last for approx. 2 minute. If
you cannot synchronise your transmitter and receiver, please enter syn-
chronising mode again.
NOTE: Wait for approx. 2 Minutes after the transmitter and receiver
have been successfully synchronized until the signal indicator
receiver goes out.

Setting the signal type

The receiver can indicate the reception of a door signal either optically
or acoustically or both optically and acoustically.
Using the signal type selector button
is to be indicated optically or acoustically or both optically and
acoustically.

Setting the volume

Press the volume button
are a total of 4 possible volume settings: very loud, loud, medium, soft.
on the receiver will then blink. This is to indi-
1
until the desired volume is reached. There
3
Operation
, select whether the signal
5
on the
1
GB/IE 13