Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
KEY TO THE MAIN COMPONENTS OF THE
APPLIANCE
1.
Carrying handle and button for automatic
cord rewind
2.
ON/OFF button
3.
Bag change indicator
4.
Lid
5.
Hose connector port
6.
Air valve
7.
Handle
8.
Hose
9.
Hose connector
10.
Two-component tube
11.
Brush function button
12.
Floor nozzle
13.
Crevice/brush nozzle
14.
Motor filter
15.
Exhaust filter
16.
Exhaust grille
17.
Exhaust (behind the grille)
18.
Storage bracket
PREPARING THE APPLIANCE
IMPORTANT! Before using the appliance,
open the lid (4) and make sure the motor filter
(14) and the dust bag have been fitted to the
appliance. Also check that the exhaust filter
(15) is in place in the exhaust port (17). See
Replacing filter and dust bag below.
1.
Attach the hose (8) to the appliance by
inserting the hose connector (9) in the hole
on the hose connector port (5) on the top
of the appliance, until you hear a click.
o
To remove the hose, press the buttons
on the side of the hose connector and
pull the hose out.
2.
Assemble the two-component tube (10),
joining the two parts
3.
Attach the handle of the hose (7) to one
end of the tube and attach the floor nozzle
(12) to the opposite end of the tube
USING THE APPLIANCE
1.
Pull the cord out of the appliance. The
cord may not be pulled out further than
the yellow mark. Plug in and switch on the
power.
2.
Press the On/Off button (2) to switch the
appliance on and off.
3.
Suction strength can also be adjusted by
opening and closing the air vent (6) on the
handle.
o
When the valve is closed, full suction is
achieved. This is the normal setting.
o
When the vent opens, more air is
allowed in, reducing the suction power
at the floor nozzle. This function is
ideal for cleaning curtains and other
light items which can easily get sucked
into the nozzle at maximum suction
strength.
4.
The floor nozzle brushes have two settings
which can be selected using the brush
function button (11) on top of the nozzle.
o
When cleaning hard surfaces (stone
flooring, tiles, etc.), the nozzle brushes
should be extended.
o
When cleaning carpets and rugs, the
brushes should be retracted into the
nozzle.
5.
If the bag change indicator (3) indicates
that the bag is full or if suction force is
significantly reduced, the bag must be
replaced (see section Replacing Dust
Bag, below). If the indicator continues to
indicate that the bag is full after you have
replaced it, this may be due to one of the
following:
o
The hose or nozzle is clogged.
o
The exhaust filter is dirty.
Investigate and resolve the problem. Do not
use the appliance if the indicator indicates
that the dust bag is full. This may cause
irreparable damage to the motor.
6.
NOTE! Switch off the appliance on the
On/Off button, disconnect the plug from
the mains socket and allow the appliance
to cool off for approx. 1 hour. Clean the
filters and replace the dust bag (see the
sections on replacement of filters and dust
bag below), before using the appliance
again.
19
Werbung
Inhaltsverzeichnis
