Factory Reset; Delete Mode - NAD M15 HD2 Bedienungsanleitung

CONFIGURING KEy
ILLUMINATION
Keys to Press
(for 3 seconds)
DISP + Digit Key
(0-9)
DISP + OFF
DISP + ON
DISP + ENTER
DISP + RTN

FACTORy RESET

The HTR 8 can be reset to its factory state,
deleting all learned commands, copied
and punched-through keys, macros,
and other setup information; reverting
all keys to their pre-programmed library
commands.
To perform a factory reset simultane-
ously press-and-hold for 10 seconds the
HTR 8's [ON] and [RTN] keys; the Learn
LED will start to flash green. Release
[ON] and [RTN] before the second flash
is complete; the Learn LED will turn red,
indicating the remote has been reset.
Note
You must release [ON] and [RTN]
before the second flash goes out, oth-
erwise the unit will not reset; should
this occur, repeat the full procedure.

DELETE MODE

The HTR 8 can store learned, copied, and
"default library" commands on any single
key. The default library commands are the
pre-programmed NAD codes, such as the
native NAD receiver commands on the
[AMP] "page".
You can delete commands by layers back
"down" to the default library command
on any key, removing learned com-
mands, punched-through functions, and
copied keys.
Note
The default library commands can-
not be deleted, so you need not worry
that using Delete Mode might cause
irreparable changes.
Mode
Set key illumination
timeout to number of
seconds corresponding
to digit key. Zero turns
off the key illumination
entirely.
Disable light sensor. Key
illumination will turn on
with any key press.
Enable light sensor.
Set the light sensor
threshold to the current
light level.
Restore all key illumina-
tion settings to the
defaults.
9