Edesa LS486 Installationsanleitung Seite 103

• Why doesn't the washing machine fill with water?
• Why doesn't the washing machine drain or spin?
• Why doesn't the washing machine spin the clothes?
• Is it better to put the detergent in the drawer or directly in the drum?
– When this fault is detected, the Wash and Rinse dis-
plays will flash in turn. If your washing machine has a
display, it will show F01.
– This water input fault could be due to an interruption
in the water supply, water input tap or because the
water input filter on the washing machine is blocked.
– Therefore, you should take the following steps: wait
until the water supply starts again, open the water
input tap or loosen the water input pipe and clean its
filter.
– When this fault is detected, the Rinse and End displays
will flash in turn. If your washing machine has a display,
it will show F02.
– Possible reasons for this fault may be: obstruction in the
drain motor pump in the washing machine, obstruction
in the drainage piping of the building or incorrect electri-
cal connection of the motor pump.
– Action: if the reason for the fault is an obstruction in the
motor-pump, follow the steps in section 2. Maintaining
and cleaning the machine.
– When this fault is detected, the Pre-wash and Wash dis-
plays will flash in turn. If your washing machine has a
display, it will show F03.
– This fault occurs because the laundry is not evenly dis-
tributed in the drum, which can cause too much vibra-
tion.
– Solution: return to the spin stage. .
The use of "detergent tablets" that go directly into the
drum is increasingly common. These tablets wash well and
do not damage the laundry. However, other powder and
liquid detergents contain aggressive components that may
damage clothes if applied directly to the garments. In this
case, we recommend you use the drawer
English
103