Technical Data; Environmental Conditions - Jackle Plasma 40i IP44 Betriebsanleitung

15. Technical data

Supply voltage 1-phase
Max. power draw
Fuse
Cutting current
Max. open-circuit voltage
40 % duty cycle
60 % duty cycle
100 % duty cycle
Max. cutting thickness, quality cut
severance cut
System of protection
Insulation class
Type of cooling
Dimensions L x W x H (mm)
Weight
Authorized for welding under increased electrical hazard
Manufactured in accordance with EN 60 974-1, EN 60 974-7 and EN 60 974-10
Generator operation:
The generator must have 30% more power as the cutting unit.
Example: 6kVA (unit) + 30% = 8kVA. The generator for this unit must have 8kVA.
A generator with less power will damage the Jäckle cutting unit as well as the generator himself
and is disallowed.

16. Environmental conditions

The power source must be operated at a temperature between -10° C to +40° C and a relative humidity of 50% at
40° C or up to 90% at +20° C. The ambient air must be free of unusual amounts of dust, acids, corrosive gases or
substances, etc., unless they occur during cutting.
Operating manual
230 V, 50/60 Hz, +/- 10%
5,6 kVA
16 A slow
20 to 40 A
460 V
40 A / 96 V
30 A / 92 V
20 A / 88 V
10 mm
15-20 mm
IP44
F (180° C)
F
590x220x410 (IP44)
16kg (IP44)
Plasma 40i
Page 14