Start-Up And Operation - Hama Opal Bedienungsanleitung

• Do not modify the product in any way. Doing so voids the warranty.
Warning
• Only connect the product to a socket that has been approved for the device. The socket must
be installed close to the product and easily accessible.
• Do not continue to operate the device if it becomes visibly damaged.
4. Startup and Operation
Note – Connecting terminal devices
• Before connecting a terminal device, check whether the power output of the charger can
supply sufficient power for the device.
• Ensure that the total power consumption of all connected terminal devices does not exceed
2100 mA.
• Please refer to the instructions in the operating manual of your terminal device.
Note – 100-240 V mains voltage
• The charger is suitable for a mains voltage of 100-240 V and can be used around the world.
Please note that a country-specific adapter may be necessary.
• You can find an appropriate selection of Hama products at www.hama.com.
• Plug the charger into an approved and easily accessible electrical socket.
• When the power supply is active, the function LED (1) lights up in green. The charger is now ready
for use.
• Connect the Micro USB connector (3) to the terminal device to be charged.
• Alternatively, you can also connect the terminal device to be charged to the USB port (2) directly or
using a suitable USB cable.
• The function LED (1) lights up in red during charging.
• When charging is complete, the function LED (1) will turn green.
• If you are charging two terminal devices at once, the function LED (1) will not turn green until both
devices are finished charging.
• Disconnect all cable and mains connections after use.
3