Electric Installation - AEG BQS 5515 Bedienungsanleitung, Garantie

Electric installation

• Be sure the voltage of the device (rating plate)
is in accordance with the mains voltage.
• Connect the mains plug to a properly installed
shockproof socket (230V~ 50Hz) only.
Connected load
The device is intended for a maximum power
intake of 000 W. This connected load recom-
mends a separate input lead secured with a
16 amp protected switch.
Caution Overload:
► When using extension cords, these should
have a cable cross-section of at least 1.5 mm².
► Do not use gang plugs, because the device
is too powerful.
The device must be supplied by a residual-cur-
rent-operated protective device (RCD) with a
release current of maximum 30mA.
Please consult a qualified electrician.
Prior first-time operation
• Slightly grease the anti-stick grill plate and put
it onto the heating coil.
• Operate the device without barbecue for 15
minutes whilst grill base is filled with water.
• Turn the temperature control (8) to the highest
position.
• The protective foils on the heating element and
grill plate will be removed.
Note:
Slight formation of smoke is thereby normal.
Ensure sufficient ventilation.
• Clean the grill plate during a rinsing bath after
it has cooled down.
Your device is now ready for use.
Operating your device
• Pour 1.5 l of cold water into the grill base until
reaching the "MAX" level.
• Preheat the operable device for about 10
minutes prior use.
• Set the temperature control according to the
intended use:
Low or middle settings for keeping warm or
cooking, highest setting for fast cooking or
barbecuing. The indicator light (9) indicates the
operation of the heating.
• Put the barbecue onto the grill plate. Turn the
barbecue from time to time.
Caution:
If the water level falls below the "MIN" marking
after long time of barbecuing, please first un-
plug the device and then add more water, until
reaching the "MAX" level.
Do not pour cold water over the hot heating
element. It might get damaged.
Switch off:
Turn the temperature control anti-clockwise as
far as it will go and unplug the device.
Troubleshooting
The thermostat is equipped with a safety switch
(A). It prevents the operation of the heating ele-
ment outside of the grill base.
If the heating cannot be switched on, please
check the mains connection and the correct fitting
of the thermostat in the grill base.
Cleaning
Warning:
► Always unplug the device and allow the
device to cool down before cleaning.
► Do not under any circumstances immerse
the heating element into water for cleaning.
Danger of electric shock or fire!
Caution:
► Do not use a wire brush or other scratching
objects.
► Do not use acrid or abrasive cleaning
agents.
Remove the grill plate and the heating element,
and take the reflector plate from the grill base.
Pour the water of the grill base away.
English
31