Operating The Inverter; Care And Cleaning - Waeco PocketPower SI102 Bedienungsanleitung

Operating the inverter

Charging the USB device
NOTE
I
Always refer to the operating manual for your USB device.
➤
To charge a rechargeable device via the USB connection, plug the USB connection
of the device into the USB charger port (fig. 1 5, page 2).
7 Operating the inverter
NOTE
I
 You can operate the inverter with the engine running or switched off. Take
note that the power supply to the 12 V socket is interrupted in some vehicles
when starting the engine.
 When operating the inverter at high load for lengthy periods, it is advisable to
start the engine in order to recharge the vehicle battery.
If the vehicle battery voltage falls below 10.8 V, the inverter switches off.
If the inverter overheats, pull out the connection cable from the socket. After it cools down,
you can plug the inverter back in.
8

Care and cleaning

WARNING!
!
Before cleaning the device, pull the connecting cable out of the vehicle socket
or the cigarette lighter.
NOTICE!
A
 Never clean the device under running water or in dish water.
 Do not use abrasive cleaning agents or hard objects during cleaning, as these
can damage the device.
➤
Wipe the outside with a damp cloth.
14
PocketPower SI102
EN