Error Messages
Symptoms
Reason
Water supply is not adequate in
area.
Water supply taps are not
completely open.
Water inlet hose(s) are kinked.
The filter of the inlet hose(s) are
clogged.
If water leakage occurred in the
inlet hose (aqua stop hose),
indicator '
' will become red.
• May vary depending on the model.
Drain hose is kinked or clogged.
The drain filter is clogged.
Load is too small.
Load is out of balance.
The appliance has an imbalance
detection and correction system.
If individual heavy articles are
loaded (e.g. bath mat, bath
robe, etc.) this system may stop
spinning or even interrupt the
spin cycle altogether.
If the laundry is still too wet at
the end of the cycle, add smaller
articles of laundry to balance the
load and repeat the spin cycle.
Solution
• Check another tap in the house.
• Fully open tap.
• Straighten hose(s).
• Check the filter of the inlet hose.
• Clean and straighten the drain hose.
• Clean the drain filter.
• Add 1 or 2 similar items to help balance
the load.
• Add 1 or 2 similar items to help balance
the load.
• Rearrange load to allow proper spinning.
• Rearrange load to allow proper spinning.
41