How to Handle Freezing
• Make sure to empty the drum, pour warm water of
50–60°C up to the rubber part inside the drum, close
the door, and wait for 1–2 hours.
CAUTION
• Do not use boiling water. It may cause burns or
damage to the product.
• Open the cover cap and hose plug used for removal
of residual water to extract water completely.
Drain plug
NOTE
• If when water does not drain, this means the ice is
not melted completely. Wait more.
34
50‒60°C
Cover cap
• When water is removed completely from the drum,
close the hose plug used for removal of residual
water, select Rinse and Spin, and press the Start/
Pause button.
Detergent drawer
NOTE
• Check that water is coming into the detergent
drawer while rinsing, and water is draining through
the drain hose while spinning.
• When water supply problems occur, take the following
measures.
– Turn off the tap, and thaw out the tap and both
connection areas of inlet hose of the product using
a hot water cloth.
– Take out inlet hose and immerse in warm water
below 50–60°C.
Inlet hose
50‒60°C
Drain hose