Description Of The Appliance; Safety Instructions; Before Using For The First Time - Electrolux zb 250 x Gebrauchsanweisung

g Dear Customer,
Please read these operating instruc-
tions carefully. Above all please
observe the safety information on the
first pages of these operating instruc-
tions! Please keep these operating
instructions for later reference. Pass
them on to any subsequent owner of
the appliance.

Description of the Appliance

1 Dust container
2 Dust filter
3 Release button
4 On/off switch
5 Charge control display
6 Charge socket
7 Wall mounting and charger
8 Mains plug
9 Jack plug
10 Fold-down crevice nozzle
1

Safety instructions

• Do not vacuum wet surfaces.
• Do not use the vacuum cleaner on sur-
faces that have been treated with
flammable solvents until they are com-
pletely dry.
• Do not use your vacuum cleaner to
vacuum hot items such as a glowing
cigarette end.
• Never use the vacuum cleaner to pick
up combustible dust.
• Under no circumstances should you oil
or grease the motor.
• Do not expose the vacuum cleaner to
direct sunlight or any source of heat.
• For maintenance and repair please
contact your local dealer or authorised
service personnel. Never attempt to
carry out repairs to the vacuum cleaner
yourself.
• Only use the appropriate original
charging devices for this model.
; This appliance complies with the fol-
lowing EC directives:
– 73/23/EWG dated 19.02.1973 "Low
Voltage Directive", including Direc-
tive Amendment 93/68/EWG
– 89/336/EWG dated 03.05.1989 "EMC
Directive", including Amendment
Directive 92/31/EWG

Before using for the first time

Before using your vacuum cleaner
for the first time you should charge
the battery for approx. 16-18 hours.
With a fully charged battery you can
vacuum for approx. 8 minutes with
model ZB 250 and for approx.
9 minutes with model ZB 254.
Attaching the wall mounting
(Fig. A)
Select a position near a room socket to
attach the wall mounting.
0 Hold the mounting against the wall
and mark the points for the fastening
screws.
0 Use a drill to drill the holes for the
screws and push in the plastic plugs
provided.
0 Position the wall mounting and then
insert the screws so that they project
by at least 7 mm.
0 Then lower the wall mounting and
tighten the screws.
The appliance can equally well be
3
stored standing on a table, the floor or
any other horizontal surface.
Charging (Fig. B)
The charger (7) may only be connected
to a power source of 230V, 50Hz.
0 Insert the vacuum cleaner into the wall
mounting (7) and check that the jack
plug (9) on the wall mounting fits cor-
rectly into the charge socket (6) on the
vacuum cleaner.
g
7