Sharp PN-V551 Installationsanleitung Seite 11

nMode setting
When the monitor is turned on for the first time after being
shipped from the factory, the mode setting screen will be
displayed.
(1)Press or to select YES or NO.
ENTER
(2)Press .
YES:
• OPERATION MODE is set to MODE1.
• OFF IF NO OPERATION is set to ON, and STANDBY
MODE is set to LOW POWER. (These settings can not
be changed.)
• If there is no operation for 4 hours or more, the monitor
automatically enters standby mode.
• Compared to when set to STANDARD, the current
consumption is reduced while the monitor is in standby
mode/input signal waiting mode, but the startup/return
time from standby mode/input signal waiting mode
becomes longer.
• While the monitor is in standby mode, control via LAN
will be disabled.
• While the monitor is in standby mode/input signal waiting
mode, only certain RS-232C commands can be used.
• While the monitor is in standby mode/input signal waiting
mode, the remote control unit cannot be used to operate
the display of the secondary unit.
• Depending on the input signal, the monitor may not
switch to input signal waiting mode and may not return
from input signal waiting mode.
NO:
• OPERATION MODE is set to MODE2.
• OFF IF NO OPERATION is set to OFF, and STANDBY
MODE is set to STANDARD.
(These settings can be changed.)
• Compared to when set to LOW POWER, the startup/
return time from standby mode/input signal waiting mode
is reduced, but more power will be consumed in standby
mode/input signal waiting mode.
Even after being set, changes can be made using
OPERATION MODE, located in MONITOR menu.
nDate/time setting
• If the time has yet to be set when the monitor is first turned
on, the date/time setting screen appears. Set the date and
time.
DATE/TIME SETTING
/ /
01 / 01 / 20
1. Press or to select the date and time, and
press or to change the numerical values.
2. Press .
ENTER
• Be sure to set the date and time.
• The date/time setting screen will close automatically if
no operation is performed for about 15 seconds. The
date and time can be set using DATE/TIME SETTING
from the SETUP menu when the date/time setting screen
disappears.
TIPS
• Set the date in "Day/Month/Year" order.
• Set the time on a 24-hour basis.
• The clock is maintained by the internal battery.
• If you already set the time but the date/time setting screen
appears when the power is turned on, the internal battery
may be exhausted. Please contact an authorized SHARP
servicing dealer or service center for assistance with
battery replacement.
• Estimated service life of the internal battery: About 5 years
(depending on monitor operation)
• The initial battery was inserted at the factory when the
monitor was shipped, so it may run out of power before its
expected operation life.
Turning Power On/Off
: :
15 00 : 00
OK···[ENTER] CANCEL···[RETURN]
9
E