Levelling; Location; Door Reversibility - AEG Electrolux S26KA78 Benutzerinformation

12
Installation

Levelling

When placing the appliance ensure that it stands
level. This can be achieved by two adjustable feet
at the bottom in front (2). If necessary adjust the
feet by removing the spacer (1).

Location

The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc. Ensure that air can circulate freely
around the back of the cabinet.To ensure best
performance, if the appliance is positioned below
an overhanging wall unit, the minimum distance
between the top of the cabinet and the wall unit
must be at least 100 mm . Ideally, however, the
appliance should not be positioned below over-
hanging wall units. Accurate levelling is ensured
by one or more adjustable feet at the base of the
cabinet. If the cabinet is placed in a corner and the
side with the hinges facing the wall, the distance between the wall and the cabinet must
be at least 10 mm to allow the door to open enough so that the shelves can be removed.
WARNING!
It must be possible to disconnect the appliance from the mains power supply; the plug
must therefore be easily accessible after installation.

Door reversibility

To carry out the following operations, we suggest that this be made with another person
that will keep a firm hold on the doors of the appliance during the operations.
To change the opening direction of the door, do these steps:
1. Remove the plug from the power socket.
1
2