AEG Electrolux ARCTIS G 8 60 50-5i Benutzerinformation Seite 42

Malfunction
Green light does not light up,
yellow light lights up when
fast freeze fuction is activa-
ted, appliance is on.
Yellow light does not light up,
when fast freeze fuction is
activated, appliance is on.
Appliance cools too much.
The freezer temperature is not
sufficient, red light blinks,
temperature signal sounds
The freezer temperature is not
sufficient, red light blinks,
temperature signal sounds
Heavy build up of frost, possi-
bly also on the door seal.
Unusual noises.
The compressor does not start
immediately after changing
the temperature setting.
Important: regularly check on the red temperature pilot lamp and thermo-
meter that the storage temperature is being maintained
42
Possible Cause
Green light faulty.
Yellow light faulty.
Temperature is set too cold.
Temperature is not properly
adjusted.
Door was open for an exten-
ded period.
A large quantity of warm
food was placed in the
appliance within the last 24
hours.
The appliance is near a heat
source.
Disturbance on the appliance
Door seal is not air tight (pos-
sibly after changing over the
hinges).
Appliance is not level.
The appliance is touching the
wall or other objects.
A component, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
This is normal, no error has
occurred.
Remedy
Please inform your customer
service
Please inform your customer
service
Turn the temperature regula-
tor to a warmer setting tem-
porarily.
Please look in the "Initial Start
Up" section.
Open the door only as long as
necessary. Press the fast free-
ze switch
Press the fast freeze switch
Please look in the "Installation
location" section.
Switch on the fast freeze
switch, keep the freezer clo-
sed, inform your customer
service
Carefully warm the leaking
sections of the door seal with
a hair dryer (not hotter than
approx. 50 °C). At the same
time shape the warmed door
seal by hand such that it sits
correctly.
Readjust the feet.
Move the appliance slightly.
If necessary, carefully bend
the component out of the
way.
The compressor starts after a
period of time.