Feed Speed Adjustment; Angle Adjustment; Annual Lubrication - Jet MBS-1014W Gebrauchsanleitung

Fig 9
The tracking is sensitive, start with ¼
turn adjustment.
Once tracking is set, tighten bolt (A)
firmly.

7.6 Feed speed adjustment

You can control the sawblade
downward feeding with the valve
control knob (F, Fig 10) and lock the
saw with the on/off valve (G).
Fig 10
The cutting of thin-walled workpieces
(profiles, tubes etc.) requires slow
feeding to avoid excessive wear of
sawblade.
7.7 Bow weight adjustment
Bow weight has been set at the
factory and should not need
adjustment.
Adjustment can be made on spring
tension screw (Fig 11).
Fig 11
7.8 Vise adjustment
Use the vise operating handwheel (J,
Fig 2) to open and close the vise for
clamping.
For quick adjustment move the rack
block (B, Fig 12) to the desired
location and engage the rack.
Fig 12
The vice can be adjusted for square
and mitre cuts.
Loosen bolts and move fixed vise jaw
to the desired angle.
Loosen the hex cap bolt (A, Fig 13)
and adjust movable vice jaw parallel
to the fixed jaw.
Fig 13
Always check the vice setup with a
combination square against the blade
and vice.

7.9 Angle adjustment

Disconnect the machine from the
power source.
Pull the handle (A, Fig 14) towards the
front of the saw.
Fig 14
7
Rotate the upper assembly to the
desired angle and lock again.
Use nut and bolt (B, Fig 15) to adjust
the 90° stop.
Fig 15
Lower the sawarm and check with a
square.
8. Maintenance and inspection
General notes:
Maintenance, cleaning and repair
work may only be carried out after
the machine is protected against
accidental starting by pulling the
mains plug.
Repair and maintenance work on the
electrical system may only be carried
out by a qualified electrician.
Clean the machine regularly.
Only use sharp and properly set saw
blades.
Replace a defective sawblade
immediately.
All protective and safety devices must
be re-attached immediately after
completed cleaning, repair and
maintenance work.
Defective safety devices must be
replaced immediately.

8.1 Annual Lubrication:

- Gearbox:
Change the hydraulic oil
DIN 51517-2 CL ISO VG 68
(e.g. BP Energol HLP68, Castrol Hyspin
AWS 68, Mobil DTE Oil Heavy Medium)
Oil level must be up to indicator mark
in oil sight glass when saw arm is
lowered.
Fill oil by removing oil filler plug on
side of gearbox (A, Fig 16)..