Basic Operation; Power On/Off; Rear View Camera - ZENEC ZE-NC2040 Bedienungsanleitung

bASIC OPERATION

POWER ON/OFF

■ Press the PWR/VOL rotary knob on the front panel to turn on the unit. Press and hold
the rotary knob for 2 seconds to turn off the unit.
■ It's also possible to turn on and off the unit with the ignition, but this depends on the last
state, before the unit was turned off.
SELECT A PLAYING SOURCE
■ After you have turned on the unit, touch the
icon with the current playing mode in the
upper left corner of the screen to go back to
the main menu.
■ After entering the main menu, you have
access to each playing mode and setting.
■ Touch the arrow to choose between the two
pages of the main menu.
Arrow

NOTE:
■ If a medium is not inserted or the external unit is not connected, the respective icon is greyed
out.

REAR VIEW CAMERA

■ The rear view camera mode will be activated automatically, if a camera is connected
to the camera input, the reverse wire has to be correctly connected (according to the
mounting manual) and you shift to the reverse gear.
M-ZONE
■ If you have installed monitors for example to the headrests of your car and they are
connected to the M-Zone A/V outputs of the unit, the passenger can operate the unit with
the rear remote control. To choose a playing mode directly (only DVB-T and DVD) at the
unit, touch the M-Zone icon in the main menu. The playing mode DVD is not available,
if you have selected the playing mode SD card or USB for the front zone. The volume of
the M-Zone components can only be altered using the with the volume adjustment of an
external unit (e.g. IR headphones).
Current playing mode
48