Original Accessories / Tools; Start-Up; Setting The Groove Depth; Installing The Dust Extraction Adapter - Parkside PMNF 1350 A1 Betriebsanleitung

Original accessories / tools

Use only the accessories and attachments de-
tailed in the operating instructions, or those which
are compatible with the device.

Start-up

Setting the groove depth

Loosen set screw
6
Set the depth stop
Tighten set screw
6
Installing the dust
extraction adapter
Slide the pegs of the extraction adapter
into the slots of the dust extraction connection.
Turn the extraction adapter
Loosen union nut
3 a
Insert the tube of the extraction unit far enough
into the opening on the union nut
Tighten union nut
3 a
Operation

Switching ON / OFF

NOTE: Always switch on the device before bringing
into contact with the material and only then apply
the device to the work piece. The wall grinder fea-
tures electronic smooth start-up. The motor's start-up
is delayed.
Switching the unit on:
Activate the switch lock
press the ON / OFF switch
Switching the device off:
Release the ON / OFF switch
General power tool safety warnings / Start-up / Operation
.
to the desired depth.
7
.
3
to lock.
3
.
.
3 a
.
(see Fig. C). Then
9
.
1
.
1
Installing and adjusting
the cutting width of the
diamond cutting discs
Loosen set screw
6
Slide the depth stop
Press and hold the spindle lock
Use the face pin wrench
adapter flange .
5
Remove the adapter flange
Set the desired cutting width with the number
of spacers . Be sure to use the centring
14
flange as the top spacer.
13
NOTE: You may choose from various spacers.
Please note, the total number of spacers between
the cutting discs and the thickness of the cutting
discs yield the groove width.
Tighten the adapter flange with the face pin
wrench . When doing so, hold the spindle
15
lock.
NOTE: When setting a cutting width smaller
than the maximum, you must use the spacers
on the clamping collar side, as the clamping
collar alone cannot secure the discs due to the
thread length on the spindle (see. Fig. D).
NOTE: Always replace diamond cutting discs
in pairs.

Handling the wall chaser

(see Fig. E)
ATTENTION! This device is only suitable for
dry cuts!
Use a cable detector to check walls for hidden
electrical-, gas- and water lines before using
the wall chaser.
Select the desired groove width.
Apply the roller
11
wall.
Now switch on the device and immerse into
the brick wall until the depth stop
Now cut the groove into the brick wall, noting
the cutting direction. The device must be rotat-
ing in the opposite direction. The device can
otherwise erratically be pushed out of the cut.
.
up.
7
.
10
to loosen the
15
.
5
of the device onto the brick
touches.
7
GB/IE 11