Futurelight PSC-250 Bedienungsanleitung Seite 44

a) Editing via the Control Board
b) Editing via the external controller
♦ Call up the first scene in your controller now.
♦ Select "SC01" by pressing [UP] button.
♦ Press [ENTER], the display shows "SC01".
♦ Press [ENTER], the display shows "C-01".
♦ Select "CNIN" by pressing [UP].
♦ Press [ENTER], the display shows "OFF".
♦ Press [UP], the display shows "ON".
♦ Press [ENTER], the display shows "SC02". You successfully downloaded the first scene.
♦ Adjust the Step-time as described above under point 12.
♦ Call up the second scene in your controller now.
♦ Repeat steps 5-11 until all desired scenes are downloaded.
♦ Press [EXIT/DN] to exit. The number of steps can be defined under "STEP" and the scenes can be called
up under "RUN"
♦ Select "SC01" by pressing [UP] button.
♦ Press [ENTER], the display shows "SCXX", "X" stands
for the scene no. to be edited.
♦ Change the scene no. by pressing [UP].
♦ Press [ENTER], the display shows "C-XX", "XX" stands
for the channel no. Such as "C-01", it means you are
editing channel 1 of the selected scene.
♦ Select the channel no. you would like to edit by pressing
[UP].
♦ Press [ENTER] to enter editing for the selected channel
, the fixture reacts to your settings. The display shows the
DMX value of the edited channel. Such as " 11XX", it
stands for channel 11 of the current scene, the DMX value
is XX , XX is a hexadecimal number value "01-FF".
♦ Adjust the desired DMX value by pressing [UP] or [DN].
♦ Press [ENTER] in order to edit other channels of this
scene.
♦ Repeat steps 5-9 until you finish setting all the DMX
values for all channels of this scene.
♦ Once all the channels completed, the display will flash
"tIME".
♦ Press [ENTER] to edit the time needed, the display
shows "t--X","X" stands for the time needed to run the
current scene, value "1-9". For example, "t--2" means you
need 2 seconds to run the current scene.
♦ Adjust the desired time by pressing [UP].
♦ Press [ENTER] to save the settings for the scene you
are editing, the display will change to the next scene
automatically.
♦ Repeat step 3-14 to edit and other scenes, you can edit
and save a maximum of 48 scenes.
♦ Press [EXIT/DN] to exit. The number of steps can be
defined under "STEP" and the scenes can be called up
under "RUN"
44/90 51839915X18NXS_V_1_1.DOC