Binding; Start - Carson Linde H40D Betriebsanleitung

bIndIng

Assigning a transmitter identifier to the
receiver (binding)
When a remote control signal is sent, in addition to control infor-
mation, an electronic identifier is sent with each transmitter burst.
This is how the receiver recognizes that the signal has come from
its own transmitter. Since many millions of transmitter identifiers
are available, it is extremely unlikely that a different transmitter
could influence your receiver.
In case the (radio) connection between the transmitter and the
model is lost, the assignment must be renewed. For this purpose,
the following procedure is required. So far as possible, it should be
undertaken at a place where no other electrical signal – especially
from another 2.4-GHz transmitter – can interfere with this trans-
mission.
1. With transmitter and model ready to operate but switched off,
position them a short distance apart.
2. Switch on the model. Press the "Setup/Binding" button; the LED
should begin to flash.
3. Now switch on the transmitter.
4. When the receiver LED is lit continuously, the binding process is
complete and the RC system is ready for use.

Start

1. first switch on the transmitter.
2. no you're ready to activate the model.
To do this, push the main switch (power) on the underside of the
model to the "ON" position.
If the wheels start to turn, trim them in the opposite direction
using the throttle trim.
ON
OFF
1
The engine and warning sounds can also be switched on using a
separate switch.
To switch off after use, switch the model off, and then the
transmitter.
OFF
Engine
ON
sounds
OFF
Warning
ON
sounds
2
Setup button
model
OFF
Power
ON
17 // gb