Miele Complete C3 Electro EcoLine Gebrauchsanweisung Seite 36

en
The Electrobrush is particularly suitable
for intensive vacuuming of carpets
which are subject to hard wear.

The Electrobrush should not be
used for vacuuming deep-pile rugs
and carpets or valuable hand-knot‐
ted rugs and carpets, e.g. Persian
and oriental rugs etc. There is a dan‐
ger of the threads being pulled out.
For further information on use and
maintenance please refer to the sepa‐
rate instructions supplied with the Elec‐
trobrush.
To attach the telescopic suction tube
to the standard floorhead / hard
floorbrush (dia. 7)
 Push the telescopic suction tube into
the floorhead / hard floorbrush and
turn it clockwise or anti-clockwise
until it clicks into position.
 To release the floorhead / floorbrush
from the suction tube, press the re‐
lease button.
Using the standard AllTeQ floorhead
Please observe the flooring manu‐
facturer's cleaning and care instruc‐
tions.
This floorhead can be used for all nor‐
mal cleaning of carpets, rugs and hard
flooring which is not susceptible to
scratching.
Using the hard floorbrush
Please observe the flooring manu‐
facturer's cleaning and care instruc‐
tions.
36
This hard floorbrush is especially suita‐
ble for vacuuming floors with deep
gaps and crevices, e.g. old wooden
flooring.
To adjust the standard AllTeQ floor‐
head (dia. 8)
Vacuum carpets and rugs with the
brush retracted:
 Press the foot control .
Clean hard flooring which is not sus‐
ceptible to scratching, as well as floor‐
ing with gaps or deep crevices in it with
the brush protruding:
 Press the foot control .
To activate the exhaust filter change
indicator
The exhaust filter change indicator
shows the remaining functional life of
the exhaust filter.
 Press the release catch for the dust
compartment lid and raise the lid as
far as it will go (dia. 9).
 Remove the indicator strips (dia. 10).
 Press the exhaust filter change indi‐
cator (dia. 11).
After approx. 10 - 15 seconds a thin red
stripe will appear in the left hand side of
the display (dia. 12).
 Close the dust compartment lid se‐
curely, making sure it clicks into posi‐
tion. Take care not to trap the dust‐
bag when doing so.
The exhaust filter change indicator
shows the remaining functional life of
the exhaust filter. After approx. 50 oper‐